Ubiquiti UniFi USW-Lite-8-PoE – 8-Port Gigabit Managed PoE+ Switch

KSh25,000 Ex VAT

The Ubiquiti UniFi USW-Lite-8-PoE is a compact, managed Layer 2 switch with eight Gigabit ports. Four PoE+ ports power access points, IP cameras, and VoIP phones over one cable each.

8 × Gigabit RJ45 ports (4 × 802.3af/at PoE+)
52W total PoE budget, up to 30W per port
16 Gbps switching capacity, 8 Gbps non-blocking throughput
1,000 VLANs, IGMP snooping, 802.1X, and ACLs
Fanless, 295 g body for desk or wall mounting
Managed via UniFi Network and the UniFi mobile app

Ubiquiti USW-Lite-8-PoE 8-port PoE+ switch
Ubiquiti UniFi USW-Lite-8-PoE – 8-Port Gigabit Managed PoE+ Switch
KSh25,000 Ex VAT

The Ubiquiti UniFi USW-Lite-8-PoE is a compact, fully managed Layer 2 switch with eight Gigabit Ethernet ports. Four of those ports supply 802.3at PoE+ power. Together, they share a 52W PoE budget.

In practical terms, the USW-Lite-8-PoE powers and connects Wi-Fi access points, IP cameras, and VoIP phones over a single cable. As a result, you do not need separate power adapters or sockets at each device.

What the USW-Lite-8-PoE Does in a Network

Small offices, shops, and homes often run a handful of powered devices. For example, two access points, a camera, and a desk phone. Each of these needs data and power.

The USW-Lite-8-PoE handles both. It sends data and power over standard Cat5e or Cat6 cable to four devices. Meanwhile, the remaining four ports connect computers, printers, NVRs, or an uplink to your router.

Furthermore, because the USW-Lite-8-PoE is a UniFi switch, it joins the same dashboard as your UniFi gateway and access points. Consequently, you manage the whole network from one place.

Eight Gigabit Ports with Four PoE+ Outputs

The USW-Lite-8-PoE has eight RJ45 ports. Each port supports 10, 100, and 1000 Mbps.

The port split is simple:

  • 4 × PoE+ ports (802.3af/at). Each port can deliver up to 30W. These power access points, IP cameras, and IP phones.
  • 4 × standard Gigabit ports. These connect non-powered devices or serve as the uplink to your router or core switch.

In addition, the PoE+ ports are auto-sensing. They detect whether a connected device needs power. Therefore, a laptop or printer plugged into a PoE port will not receive power it cannot use.

PoE Budget: What 52W Can Power

The total PoE budget on the USW-Lite-8-PoE is 52W. This is shared across the four PoE+ ports. In other words, the combined draw of all powered devices must stay under 52W.

For example, typical loads include:

  • UniFi Wi-Fi access points – most draw between 6W and 13W
  • Fixed IP bullet or dome cameras – often 4W to 8W each
  • IP desk phones – usually 3W to 6W each

As a result, four standard access points or four fixed cameras fit within the budget. However, a single port can reach 30W, so high-draw devices such as PTZ cameras or larger access points reduce how many others you can run. We recommend adding up the rated power of each device before purchase.

Switching Performance

The USW-Lite-8-PoE runs all eight ports at Gigabit line rate. Here is what the figures mean:

  • 16 Gbps switching capacity. This is eight ports × 1 Gbps × 2 (full duplex).
  • 8 Gbps non-blocking throughput. Every port can send and receive at full speed at the same time.
  • 12 Mpps forwarding rate. This handles small-packet traffic such as VoIP calls without dropped frames.
  • 0.5 MB packet buffer. This absorbs short bursts, such as several cameras sending video at once.
  • 8,000-entry MAC address table. This is ample for a small office or home network.

Layer 2 Management and Security Features

Although the USW-Lite-8-PoE is an entry-level switch, it includes the same Layer 2 feature set as larger UniFi switches. This means you can segment and secure a small network properly.

Key features include:

  • Up to 1,000 VLANs plus Voice VLAN for separating staff, guest, CCTV, and VoIP traffic
  • LACP link aggregation for bonded uplinks
  • STP and RSTP with loop protection to stop broadcast storms
  • IGMP snooping with querier, fast leave, and router port options for multicast video
  • 802.1X control for port-based access
  • DHCP snooping and guarding to block rogue DHCP servers
  • MAC-based and IP-based ACLs (128 entries each) with device and network isolation
  • Port isolation, port mirroring, and MAC-based port restriction
  • Storm control, egress rate limiting, flow control, and multicast/broadcast rate limiting
  • Jumbo frames and LLDP-MED for device discovery

Managed Through UniFi Network

The USW-Lite-8-PoE is set up and monitored in the UniFi Network application and the UniFi mobile app. Once adopted, you can assign VLANs, create port profiles, and see per-port traffic.

Moreover, you can power-cycle a PoE port remotely. This is useful when an access point or camera freezes at a site you cannot visit right away. Similarly, firmware updates are pushed from the same dashboard.

In addition, front-panel LEDs show system status, link speed, and PoE activity. Green indicates a 1 Gbps link, amber indicates 10/100 Mbps, and a separate amber LED confirms PoE output.

Compact, Fanless, and Low-Power Design

The USW-Lite-8-PoE measures only 99.6 × 163.7 × 31.7 mm and weighs 295 g. Therefore, it fits on a desk, a shelf, or a wall inside a small cabinet.

The switch is fanless. As a result, it runs silently in offices, bedrooms, and reception areas.

Power comes from an included external 54V, 60W adapter. The switch itself draws 8W without PoE load, and up to 60W with full PoE output. Heat output is 27.3 BTU/hr, excluding PoE.

For Kenyan homes and offices that run on a UPS or inverter during KPLC outages, this low base draw matters. Because the switch also powers your access points and cameras, a single UPS on the USW-Lite-8-PoE keeps Wi-Fi and CCTV running during a power cut.

Environmental Ratings

The USW-Lite-8-PoE is rated for ambient temperatures from -15°C to 40°C and 10–90% non-condensing humidity. The enclosure is polycarbonate.

Since the unit is fanless, leave a little space around it for airflow. This is especially important in enclosed cabinets or warmer locations such as Mombasa.

USW-Lite-8-PoE vs. USW-Ultra vs. USW-Lite-16-PoE

Buyers often compare the USW-Lite-8-PoE with nearby UniFi models:

  • USW-Lite-8-PoE: 8 × GbE, 4 × PoE+, 52W budget, external adapter
  • USW-Ultra: 8 × GbE, 7 × PoE+ outputs, powered by PoE++ input or adapter
  • USW-Lite-16-PoE: 16 × GbE, 8 × PoE+, 45W budget

In short, the USW-Lite-8-PoE suits sites with up to four powered devices. Sites with more PoE devices should look at the larger models.

Frequently Asked Questions

How many PoE ports does the USW-Lite-8-PoE have?

The USW-Lite-8-PoE has four PoE+ ports. The other four ports are standard Gigabit ports without PoE.

What is the PoE budget of the USW-Lite-8-PoE?

The total PoE budget is 52W, shared across four ports. Each port can supply up to 30W.

Does the USW-Lite-8-PoE include a power adapter?

Yes. The USW-Lite-8-PoE ships with an external 54V, 60W power adapter.

Can the USW-Lite-8-PoE power Hikvision or other non-UniFi cameras?

Yes. The PoE+ ports follow the IEEE 802.3af/at standard. Therefore, any standards-based PoE or PoE+ camera, phone, or access point can be powered, within the 52W total budget.

Does the USW-Lite-8-PoE have SFP ports?

No. The USW-Lite-8-PoE has eight copper RJ45 ports only. It has no SFP or 10G ports.

Do I need a UniFi controller to use the USW-Lite-8-PoE?

The switch passes traffic out of the box. However, VLANs, PoE control, and other managed features require the UniFi Network application. This runs on a UniFi gateway, a Cloud Key, or a self-hosted server.

Who Is the USW-Lite-8-PoE Best Suited For?

  • Small offices and shops. Four PoE+ ports power two to four access points or IP phones, while four Gigabit ports connect PCs, printers, and the router.
  • Small CCTV installs. The 52W budget runs up to four fixed IP cameras, and IGMP snooping keeps multicast video from flooding the network.
  • Homes with UniFi Wi-Fi. The fanless, 295 g body sits quietly on a shelf and powers ceiling-mounted access points over one cable each.
  • Sites on backup power. An 8W base draw and centralised PoE let one UPS keep Wi-Fi and cameras online during outages.
  • IT contractors and MSPs. UniFi Network allows remote setup, PoE port power-cycling, and firmware updates across client sites.
  • Home labs and small server corners. 1,000 VLANs, ACLs, and port mirroring support network segmentation and testing at low cost.